User Guide
Table Of Contents
- Amendment Record Sheet
- Copyright
- Warnings and cautions
- For your safety
- Care and maintenance
- ESD protection
- Battery information
- Company Policy
- Nokia 3610 fold Service Manual Structure
- 1 General information
- 2 Service Tools and Service Concepts
- 3 BB Troubleshooting and Manual Tuning Guide
- General BB troubleshooting guidelines
- Phoenix self tests
- ST_CURRENT_CONS_TEST troubleshooting
- ST_SLEEPCLK_FREQ_TEST troubleshooting
- ST_SLEEP_X_LOOP_TEST troubleshooting
- ST_UEM_CBUS_IF_TEST troubleshooting
- Power and charging troubleshooting
- Interface troubleshooting
- User interface troubleshooting
- Camera module troubleshooting
- Audio troubleshooting
- Bluetooth troubleshooting
- Baseband manual tuning guide
- 4 RF troubleshooting
- 5 System Module
- Glossary
MJ-134 Module jig
MJ-134 is meant for component level troubleshooting.
The jig includes an RF interface for GSM and Bluetooth. In addition, it
has the following features:
• Provides mechanical interface with the engine module
• Provides galvanic connection to all needed test pads in module
• For GSM 850, GSM 900, GSM 1800 and GSM 1900 bands, use CA-128RS
cable connected to right angle mouth SMA connector on fixture.
• Use losses for CA-128RS cable for correct attenuation values for
accurate testing and calibration. For GPS (1485 MHz) band, use
CA-128RS with XRS-6 RF cables. CA-128RS connects to jack X6201
located component side top of module. Add losses for CA-128RS RF
cable to losses for XRS-6 RF cable for correct attenuation values for
accurate testing and calibration. For Bluetooth (2500 MHz) band,
use instructions for SB -6 (or JBT-9).
• Multiplexing between USB and FBUS media, controlled by Vusb
• MMC interface
• Duplicated SIM connector
• Connector for control unit
• Access for AV- and USB connectors
For RF attenuation values, see Attenuation values for CA-128RS
(page 2–16).
Spare parts for MJ-134:
• TEST PINS 1 PC = 10 PINS (780009)
• TEST PINS 1 PC = 10 PINS (770879)
• TEST PINS 1 PC = 10 PINS (780447)
• TEST PIN(S) (770442)
• PWB FLEX 2AW ASSY (9855326)
PK-1 Software protection
key
PK-1 is a hardware protection key with a USB interface. It has the same
functionality as the PKD-1 series dongle.
PK-1 is meant for use with a PC that does not have a series interface.
To use this USB dongle for security service functions please register
the dongle in the same way as the PKD-1 series dongle.
PKD-1 SW security device
SW security device is a piece of hardware enabling the use of the
service software when connected to the parallel (LPT) port of the PC.
Without the device, it is not possible to use the service software.
Printer or any such device can be connected to the PC through the
device if needed.
RM-429
Service Tools and Service Concepts
Issue 1 COMPANY CONFIDENTIAL Page 2 –9
Copyright © 2008 Nokia. All rights reserved.