User Guide

RH-21 Company Confidential
System Module Nokia Customer Care
Page 28  2004 Nokia Corporation. Issue 2 07/2004
UPP Block signals
MEMADDA(23:0)* See Table 16. Memory Interface Signals / MEMADDA(23:0)*
MEMCONT(9:0) See Table 16. Memory Interface Signals / MEMCONT(8:0)
GENIO(28:0) See Table 16. Memory Interface Signals / GENIO(28:0)
RIP
Signal
name
Connected
from - to
UPP
I/O
Signal Properties
A/D Levels-Freq./
Timing resolution
Description / Notes
GENIO(28:0) General I/O Pins. Bolded lines are only valid for one product
0Switch con-
trol for
SGND Vdd
UPP Out Dig 0-1.8 V In/Pull
Up
Used to enable/disable
power to DLR-3 cable
1 Emu/Present UPP In Dig 0-1.8 V In/Pull
Up
R&D only
2 RTS UPP In Dig 0-1.8 V In / Pull
Up
Used as request to send
input from DLR-3 cable
RFCONVDA(5:0) See UEM / RFCONVDA(5:0)
RFCONVCTRL(2:0) See UEM / RFCONVCONTR(2:0)
AUDUEMCTRL(3:0) See UEM / AUDUEMCTRL(3:0)
AUDIODATA(1:0) See UEM / AUDIODATA(1:0)
ISIMIF(2:0) See UEM / ISIMIF(2:0)
PUSL(2:0) See UEM / PUSL(2:0)
IACCDIF(5:0) See UEM / IACCDIF(5:0)
RFCLK & GND See BB_RF IF Conn / RFCLK (not BUS …)
RFICCNTRL(2:0) See BB_RF IF Conn / RFICCNTRL(2:0)
GENIO(28:0)/rips 5 and 6 See BB_RF IF Conn / GENIO(28:0) also Sec 5.2.4
Ri
p
#
Signal
Name
DAMPS/
GSM1900
Connected
from --- to
UPP
I/O
Signal Properties
A/D--Levels---Freq./
Timing resolution
Description / Notes
UPP Globals, no bus, no rip Power supplies and GND
VIO UPP UEM
In Vreg
1.8 V
+- 4.5 %
20mA max. UPP I/O power supply
VCORE UPP UEM
In Vreg
1.0-1.8 V
+- 5 %
100mA
max.
UPP logics and processors power supply,
settable to reach the speed for various clock
frequencies.
GND UPP VSSXXX 0 Global GND