User Guide

PAMS Technical Documentation System Module & UI
NHM-8NX
Issue 1 05/02 ãNokia Corporation Page 63
• LOCAL-state is for manufacturing, service and R&D -purposes
• Mobile terminal acts as a slave for the service PC
• Server can't start any action from event other than ISI messages
•UI inactive
• Permanent data, including UI data, reading/writing available with ISI messages
through PERM server.
• SW entity must accept the factory set request
• Phone can't receive and create a call (CS in idle)
• Charging not allowed.
LOCAL state is entered automatically from POWER-OFF if service battery is connected.
Test points
Test points/pads with references to the bf4a schematic exist on the PWB for the priority
of the used signal lines, an exception is the address and databus for the memory.
BSI resistor Btemp resistor Activated mode when supplied
0 – 1k > 1k Local mode
0 – 1k 0 – 1k Local mode (Fast start-up)
> 1k 0 – 1k Test mode (Fast start-up)
56k - 130k > 4k Normal mode