User Guide
Table Of Contents
- Amendment Record Sheet
- Copyright
- Warnings and cautions
- For your safety
- Care and maintenance
- ESD protection
- Battery information
- Company Policy
- Nokia 3500c Service Manual Structure
- 1 General information
- 2 Service Tools and Service Concepts
- 3 BB Troubleshooting and Manual Tuning Guide
- Baseband troubleshooting overview
- Power and charging troubleshooting
- Interface troubleshooting
- User interface troubleshooting
- Audio troubleshooting
- Introduction to acoustics troubleshooting
- Audio troubleshooting test instructions
- Earpiece troubleshooting
- Internal earpiece troubleshooting
- External headset earpiece troubleshooting
- IHF troubleshooting
- IHF troubleshooting
- Microphone troubleshooting
- Internal microphone troubleshooting
- External headset microphone troubleshooting
- Connections troubleshooting
- Baseband manual tuning guide
- 4 RF Troubleshooting and Manual Tuning Guide
- 5 System module
- Glossary
Programming is completed when
Flashing Completed
message is displayed.
The product type designator and MCU SW version are displayed in the status bar.
vi Close the
SW Update
window and then choose File→Close Product .
2. Create a
Request
file.
For this procedure, you must supply +12 V to CU-4 from an external power supply.
i To connect the phone with
Phoenix
, choose File→Scan Product .
ii Choose Tools→Certificate Restore .
RM-272; RM-273
BB Troubleshooting and Manual Tuning Guide
Issue 1 COMPANY CONFIDENTIAL Page 3 –45
Copyright © 2007 Nokia. All rights reserved.