User Guide
Table Of Contents
- Amendment Record Sheet
- Copyright
- Warnings and cautions
- For your safety
- Care and maintenance
- ESD protection
- Battery information
- Company Policy
- Nokia 3500c Service Manual Structure
- 1 General information
- 2 Service Tools and Service Concepts
- 3 BB Troubleshooting and Manual Tuning Guide
- Baseband troubleshooting overview
- Power and charging troubleshooting
- Interface troubleshooting
- User interface troubleshooting
- Audio troubleshooting
- Introduction to acoustics troubleshooting
- Audio troubleshooting test instructions
- Earpiece troubleshooting
- Internal earpiece troubleshooting
- External headset earpiece troubleshooting
- IHF troubleshooting
- IHF troubleshooting
- Microphone troubleshooting
- Internal microphone troubleshooting
- External headset microphone troubleshooting
- Connections troubleshooting
- Baseband manual tuning guide
- 4 RF Troubleshooting and Manual Tuning Guide
- 5 System module
- Glossary
• Set Operation mode to “Burst” (Default).
• Set Tx data type to “All1” (Default).
• Set Rx/Tx channel (see table below)
• Set Edge to “Off” (Default).
• Set Tx PA mode to “High” (Default).
• Set power level (see table below)
Band Channel (RX and TX) TX power level
GSM850 190 5
GSM900 37 5
GSM1800 700 0
GSM1900 661 0
Figure 22 RF Controls window
RM-272; RM-273
RF Troubleshooting and Manual Tuning Guide
Page 4 –16 COMPANY CONFIDENTIAL Issue 1
Copyright © 2007 Nokia. All rights reserved.