User Guide

RH-37
6(b) - RF Troubleshooting Instructions Nokia Customer Care
Page 26 Nokia Corporation Issue 1 07/04
TX Data Type All 1
Edge On
The setup should now look like this:
Now the measurement equipment should detect the following output signal of the
phone:
P
out
= +21.5 dBm @ 1747.8 MHz
If this is not the case, then go to the EDGE fault finding chart for GSM1800 transmitter.
Fault finding chart for GSM1800 transmitter
In the following, it is assumed that the TXP signal is used as trigger signal. For that, a
TXP test point is provided.