User Guide

PAMS
Technical Documentation
NSE 8/9
Service Software Instructions
Page 42
Issue 1 07/99
Not valid
RUNNING....
Note that power–off test have no values, because if test has been passed, power has
been turned off. If power–off test fails a special error message window is shown. If no
response is received to power off test message in a few seconds, the user is informed by
special info window, where user is asked to turn the power on and then press the return
key.
Note also that power–off test (if passed) turns power off and power should be
reconnected by using the phones keypad after the successful test. After the power has
been connected to phone, the normal start–up routines are made and the self–test
results are shown in the MCU self–tests menu (i.e. all other than power–up self–tests are
in Not executed state after the power–up routines).
Run button (ALT+R):
User can select desired test from list and hit Run button. When user
selects test to be run the text
RUNNING... is shown in test state field and
test is run. When results are received the test state field is updated
according to the result.
If no response was received in the defined time, a
error message box will
be shown and the test state is changed to
No response . Phone is set to
local mode if it is not already there.
Run A
ll button (ALT+A):
User can run all listed tests. The text
RUNNING... is shown in test state
field and test is run. When results are received the test state field is
updated according to the result. When state field is updated application
moves to next test and repeats previous cycle. Phone is set to local mode
if it is not already there.
Supported Self Tests
The following tests are available:
1 MCU ROM Checksum................
2 MCU RAM Interface...............
3 MCU RAM Component...............
4 MCU EEPROM Interface............
5 MCU EEPROM Component............
6 Not Used.....................
7 CCONT Interface.................
8 A/D Converter...................
9 SW Reset........................
A Power Off.......................