User Guide

PAMS
Technical Documentation
NSE 8/9
Service Software Instructions
Page 38
Issue 1 07/99
Burst radio button (ALT+B):
When
burst selection is used,
synthesiser is controlled by using
receiving/transmission/measuring synthesiser control sequence
synthesiser channel numbers are as given with
Channel/Monitoring Channel selections
if Active Unit is TX, data (selected with TX Data Type) is sent
and the TX power is connected
Note! Function is activated immediately, Apply is not needed.
TX Data Type drop list (ALT+D):
TX Power Level edit box (ALT+T):
It is possible to change the transmission power in TX mode. The user can
select the needed power value or select the test value, which is tuned with
TX power tuning function. The test value is found at the end of the list.
TX Power have value
OFF and is disabled ( greyed ) when active unit is
RX. When the TX power is tuned with test value (smallest value) the TX
Power has value
TEST .
Continuous Mode Channel edit box (ALT+C):
Here the user can enter the continuous mode channel which may have all
channel numbers. The used frequency depends on the Active Unit. If
Active Unit is RX, then RX frequency is used, else TX frequency. The
frequency of the selected channel is shown after selection.
Ch
annel edit box (ALT+H):
Here the user can enter the channel number that is used for both
transmission and receiving. The frequency of the selected channel is
shown.
Monitoring Channel edit box (ALT+M):
This field selects the neighbour monitoring channel. The frequency of the
selected channel is shown.
AGC A
bsolute edit box (ALT+A):
This selection allows user to edit AGC absolute value (value from A/D
converter). When AGC Absolute value is changed the AGC dB value will
be calculated depending on the AGC Absolute value.
Front End On check box:
This selection allows user to change whether the Front End amplifier is On
or Off.