User Guide

PAMS
Technical Documentation
NSE 8/9
Service Software Instructions
Page 37
Issue 1 07/99
RF Information window is updated
The RX value is always given as default.
Note! Function is activated immediately, Apply is not needed.
TX radio button (ALT+T):
When
TX is selected, the next functions are made:
Data transmission is activated
If operation mode is continuous,
– Operation mode is set to burst
RF Information window is updated
Continuous mode radio button is disabled.
Note! Function is activated immediately, Apply is not needed.
Operation Mode group:
Continuous radio button (ALT+C):
When
continuous selection is used,
synthesiser is set to constant frequency
synthesiser channel number is as given with Continuous Mode
Channel selection
transmitter power is not connected
if Active Unit is RX, AGC is controlled
Note! Function is activated immediately, Apply is not needed.