User Guide

PAMS
Technical Documentation
NSE 8/9
Service Software Instructions
Page 33
Issue 1 07/99
The settings to be selected are:
1. Run battery & charger default values checkbox (ALT+1):
Loads battery & charger default values to phone when selected.
2. Battery voltage checkbox (ALT+2):
Calibrates battery voltage A/D value.
3. Charger voltage checkbox (ALT+3):
Calibrates charge voltage A/D value.
The user is asked to connect the correct charging voltage and current
limit.
4. VDC Out (DC/DC) checkbox (ALT+7)
Calibrates the VDC Out voltage from the DC/DC converter.
This calibration is special for the NSE–8 phone. When this calibration is
executed a VDC Out input field is shown. The voltage must be measured
and entered into this field and then the Calibrate button completes the
calibration.