User Guide

PAMS
Technical Documentation
NSE 8/9
Service Software Instructions
Page 29
Issue 1 07/99
Base level calculation check box:
If this box is checked the base level is calculated.
+/– buttons (+/– and left/right cursor keys):
+ and – buttons will cause power changing by 0.25dB steps. When these
keys are used the coefficient value is updated on the tuning window.
Save button (ENTER):
Dialog is closed and tuned values are
saved to phone.
Cancel button (ESC):
Dialog is closed and tuning
is not saved to phone.
When selections are used, the power value checking is made and if it is
not succeeded, error message is shown. The test checks that all power
coefficients are in descending order (same order than power levels).
If the power tuning function is ended and EEPROM values are not
received or EEPROM fault is noticed, an error message is shown.
When all power coefficients have such values that they don’t cause any
error messages, save can be made. The last used tuning power is in use
after exit.
The next automatic selection is made when this tuning function is ended:
Operation Mode = RX pulsed
When the tuning dialog is closed the DC/DC converter is set to the mode
specified specified in TESLA.INI in the section:
[NSE–8TXPOW]
DC2DC_Exit=0 ;0=Auto Mode 1=Abs Mode and 2=Max
Mode
Auto Mode is the default mode set at installation time.