PAMS Technical Documentation NSE–8/9 Series Transceivers Disassembly Issue 1 07/99
PAMS NSE–8/9 Disassembly Technical Documentation CONTENTS Page No Dis–assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Removing the B cover . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Removing Battery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Removing the A–cover . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PAMS NSE–8/9 Technical Documentation Disassembly Dis–assembly Removing the B cover STEP 1 Remove the B–cover Push down Release–button 1 Slide B–cover approx.: 5 mm in direction 2 Lift the B–cover up 3.
PAMS NSE–8/9 Disassembly Technical Documentation Removing Battery STEP 2 Remove the battery by pushing the snap 1, Rotate around the end of the battery and remove it upwards according to 3.
PAMS Technical Documentation NSE–8/9 Disassembly Removing the A–cover STEP 3 Remove the A–cover Issue 1 07/99 Page 5
PAMS NSE–8/9 Disassembly Technical Documentation Removing the antenna and the D–cover STEP 4 Remove the antenna, one side at a time Only use angled tweezers. 1.Carefully push the end in between the side of the Antenna and the D–cover. 2.Bend out the side of the antenna carefully and lift the antenna out of the snap fit.
PAMS NSE–8/9 Technical Documentation Disassembly STEP 5 Remove the screws (4x). When assembling, screw torque should be 30Ncm. with a Screwdriver speed 500–600rpm STEP 6 Remove the D–cover ! Snap Fitting ! Open one side at the time Push a screwdriver in under the D–cover side flap 1 and bend out the side of the C–cover in the direction shown, 2.
PAMS NSE–8/9 Disassembly Technical Documentation Removing the microphone, bottom–connector and PCB STEP 7 Remove the Microphone and boot, by pulling straight up.
PAMS NSE–8/9 Technical Documentation Disassembly STEP 9 Lift up the PCB Removing the dome–sheet, display and multi–gasket STEP 10 Remove the dome–sheet Issue 1 07/99 Page 9
PAMS NSE–8/9 Disassembly Technical Documentation STEP 11 Remove the display assembly STEP 12 Remove the multi–gasket Page 10 Issue 1 07/99
