CC Technical Documentation RM-11 Series Transceivers Disassembly Issue 1 02/2004 Confidential ©2004 Nokia Corporation
RM-11 Disassembly CC Technical Documentation Step-by-Step Disassembly Instructions Always use ESD protection when assembling or dissasembling a phone. Figure 1: ESD protection equipment Disassembly Instructions Step-by-Step Disassembly Instructions (Model 3205) 1. Hold the phone with the top down, facing you. Press the Release Key and push the battery cover out from the phone in the direction indicated (see arrows in the above photo). 2.
RM-11 Disassembly CC Technical Documentation Step-by-Step Disassembly Instructions (Model 3205) 5. Remove the six screws that hold the C-Cover in place (torque 21Ncm and speed 480rpm). 6. Remove the PWB/UI module from the C-Cover. 7. Remove the UI module from the engine module. Note: The UI module and the engine board are linked together by two board-to-board connectors. Be careful not to touch them. UI module and engine module after separation. 8.
RM-11 Disassembly CC Technical Documentation Step-by-Step Disassembly Instructions (Model 3205) 10. Open the snaps on both sides of the Display shield and remove the shield. Note: Be careful not to damage the shield. 11. Remove the LCD Module by holding the UI module in one hand while loosening the LCD frame a little at the same time at one side. Press the LCD module gently from the same side you are loosening until the LCD Module detaches. Note: Be careful not to damage the sensitive parts.
RM-11 Disassembly CC Technical Documentation Step-by-Step Disassembly Instructions (Model 3205) 15. Lift the DC Jack out of its place. Note: Be careful not to damage the C-Cover when removing the DC Jack. 16. Use tweezers to lift the Release Spring. 17. Remove the Release Key. 18. Remove the A-cut cover from the A-Cover. 19. Remove the B-cut cover from the B-Cover. 20. Pry the battery out of the phone as indicated.
RM-11 Disassembly Page 6 CC Technical Documentation ©2004 Nokia Corporation Confidential Issue 1 02/2004
