User Guide
Table Of Contents
- Troubleshooting - Antennas
- Contents
- Troubleshooting - Antennas
- Failures and Corrective Measures
- Missing Internal Antenna Cap
- Missing Antenna Radiator
- Missing GPS Antenna, Damaged GPS Feed/Ground Pin, or Damaged Heat Stake
- RF Feed Pin/Ground Pin, IHF Speaker Pins in C-cover Missing or Damaged
- Obstructed RF Feed/Ground Pads, GPS Feed/Ground Pads, IHF Speaker Pads
- CDMA or GPS RF Connector Failure
- Display Assembly
- Missing or Damaged Baseband Shield
- Back to MAIN TOC
CC Technical Documentation Troubleshooting - Antennas
RM-11
Issue 1 02/2004 ©2004 Nokia Corporation Confidential Page 9
Wrong Display Assembly Installed
Figure 8: Side view of RH-34 and RM-11 display assembly
Figure 9: Back view of RH-34 and RM-11 display assembly
The RH-34 (6585) and RM-11 (3205) display assemblies are very similar. However, the
side of the RM-11 display shield is different than the side of the RH-34 display shield
(see Figure 8). In addition, the metal plating at the top area of the RM-11 frame is
different from the top of the RH-34 frame (see Figure 9). For the RH-34 frame, the screw
boss area is plated but isolated from the rest of the frame, and also there is no plating in
the top area. For the RM-11 frame, the whole top area is fully plated.
If the wrong display shield or frame is installed, replace it with a correct one.
RH-34 display shield
RM-11 display shield
No plating
RH-34 display
frame plating
RM-11 display
frame plating