User Guide

CC Technical Documentation Service Software Instructions

RM-11

Phoenix User’s Guide

Figure 1: Phoenix introduction screen

Introduction

This section briefly describes how to install Phoenix and includes some basic information

on how to use the program. More detailed information can be found in the Phoenix Help

files. Each feature in Phoenix has its own Help file, which can be activated while running

Phoenix. To activate a Help file while Phoenix is running, press the F1 key or the specific

feature’s Help button.

General Setup Procedure

Initial installation of Phoenix requires the complete Phoenix installation package. This

package, around 30 Megabytes in size, is provided on a CD-ROM disk. Because of this

large size, it is not recommended to download the file nor is it practical to provide it on

3.5-inch floppy disks.

Initial installation of Phoenix requires the complete Phoenix installation package, which

is around 30 MB. Because of its large size, Diego is provided on a CD rather than on a

3.5" floppy or as a download. To install Phoenix, follow the steps as outlined in the

material that comes with the CD.

Note: You MUST have a Nokia dongle installed on the computer prior to beginning the software

installation.

The Phoenix software is packaged into an executable bundle that allows you to

double-click the executable to access the automatic installation program. Standard

installation (i.e., selecting all of the default choices) is highly recommended. You may do

a custom installation and place Phoenix into a special location on your hard drive, but

this is only recommended for experienced users.