User Guide

DTX-3
Service Software CCS Technical Documentation
Page 4 Nokia Corporation. Draft 2 3/03
When connecting PKD–1 to the parallel port, be sure that you insert the computer side of
the PKD–1 to the PC (male side). If you use a printer on parallel port 1, install the PKD–1
between the PC and your printer cable.
The PKD–1 should not affect devices working with it. If some errors occur (errors in
printing are possible) please try printing without the PKD–1. If printing is OK without the
PKD–1 please contact your dealer. We will offer you a new PKD–1 in exchange for your
old one.
Installing the Service Software on PC Hard Disk
The program is delivered on a diskette and is copy protected with a PKD–1 dongle. It
must be present in parallel port when using Service Software.
The program must be installed on the hard disk before use.
Keep the original diskette safe to enable upgrading of the program !
Flash Prommer (FPS-4)
Installation instructions can be found at the following intranet address:-
http://www.nmp.nokia.com/sasw/projects/prommer/manual/manual.htm
First time installation of WinTesla:
Do the following to make a complete WinTesla installation with support for DTX-3:
Insert the WinTesla software diskette into the floppy drive on your computer (i.e. Drive
A:)