User Guide

RH-48

Service Software Instructions CCS Technical Documentation

Hardware Requirements for using Phoenix

Installing Phoenix

Before installing the software, verify:

• The dongle is attached to the parallel port for PKD version dongles, or an FLS-4 version

dongle is attached on either the parallel port or the USB port (if the computer supports

USB).

• Ensure that if the computer supports administrator rights (typically on Windows NT

and Windows 2000 installations) that access is enabled for the user performing the

Phoenix installation.

• If a previous version of Phoenix has been installed, it may be necessary to first properly

remove that program prior to installing the new version. If installation is performed,

be sure to reboot the computer prior to continuing. See the section Uninstalling

Phoenix for instructions on how to uninstall.

Installation Directions

• Insert the CD-ROM disk into the computer drive

• Access the drive and double-click on the Phoenix software package found on the CD.

• Follow the on-screen prompts to conclusion.

Note that rebooting the computer may be necessary when completed.

Software Support Bundles

The Phoenix installation is auto-executable. You must obtain Software Support Bundles

Minimum Hardware Requirements

Processor 233 MHz

RAM1 64 MB

Disk space needed 50-100 MB

Supported Operating

Systems

Notes

Windows 95 Limited, no USB support

Windows 98

Windows NT 4.0 no USB support

Windows 2000 Professional version