User Guide

RH-48

Service Software Instructions CCS Technical Documentation

Select the Virtual COM port setting. Then press the Apply button.

You can now proceed with the normal initiation of a session.

Scanning for a Product

Many features of this program are product-specific. Therefore, it is necessary to config-

ure Diego at the beginning of a session for the product on which you will be working.

Scanning of the product can be done manually or automatically. The default setting is

automatic. This setting can be changed to manual in the “settings” – “general” box. In

automatic mode, Diego will automatically scan for a product at a periodic rate. The scan

rate is defaulted to every 5 seconds, but it can be changed to a different frequency in the

Setup menu.

To manually scan for a product, click on the “Settings” icon as noted above.

Using Components

When working with Diego, tasks are generally managed by specific software compo-

nents. From the icons displayed on the left side of the screen, select the desired compo-

nent or task to be performed.

“Opening a component” is defined as opening a tool window within Diego. When this

window is opened, Diego also opens a task box for it, which includes component-spe-

cific menu items.

Uninstalling Diego

As mentioned in the Installing Diego section, it may be necessary or desirable to remove

Diego. Care must be taken to follow this procedure. Failure to remove the program

properly will cause misconfiguration of the computer’s registry.