User Guide

RH-48
Troubleshooting - RF CCS Technical Documentation
Page 30 ©2003 Nokia Corporation Confidential Issue 1 11/2003
Synthesizer Setup
Use the following steps to set up the phone for Tx troubleshooting in Phoenix.
1Open the Phone Control dialog box.
Figure 19: Phone Control dialog box for Tx troubleshooting
2 Click the LOCAL button in the Phone State area to put the phone into Local
Mode.
3 Use the following settings for the Band, Channel, and Mode fields on the RF
Main Mode dialog box:
• UHF: Use the Rx/Tx mode in Cell band. This allows you to check power in both
the Rx and Tx circuits.
• Rx VHF: Use the Rx mode. One band is enough.
• Tx VHF: Use the Rx/Tx mode in Cell band.
Figure 20: RF Main Mode dialog box for synthesizer troubleshooting