User Guide

TME-3
Tuning, Flashing and Final Testing Instructions PAMS Technical Documentation
Page 18 Nokia Corporation. Issue 3 10/03
M2M Connector Final test
Figure 12: M2M connector test using SB-1 service box
For M2M connector testing please refer also to SB-014 “Quick Guide for Testing of M2M
System Connector”
Testing Procedure (TME-3 in Normal Mode without test SIM card):
- Check that LED’s are alternate blinking red /green (pins 1,3,5,7)
- Open Remote I/O Control & Audio settings Testing (pins 31,33,36,37,39,40,42,43)
- Mark Up Output 1,2 and 3 in Aif Interface output Control field
- Press Write button
- Press read button in Aif Interface Input Control window and check that Input 1,2 and 3
are marked.
- Mark Up Output 4 and 5 in Aif Interface output Control field
- Press Write button and check if Output 4 and 5 leds on SB-1 are on.
- Unmark Output 1-5 and press Write button in Aif Interface output Control field
- Press read button in Aif Interface Input Control window again and check that Input 1,2
and 3 are not marked.
- Check that Output 4 and 5 leds on SB-1 are off.