User Guide

PAMS Technical Documentation Tuning, Flashing and Final Testing Instruc-
TME-3
Issue 3 10/03 Nokia Corporation. Page 17
Preparation for RF Final test:
- Put test SIM card to TME-3.
- Connect TME-3 to DTX-3.
- Connect RF cable between TME-3 and RF Tester.
- Connect standard landline telephone set to trunk connector of DTX-3.
Carry out RF Final test
- Start GSM 900/1800 finaltest.
- When RF tester asks to power on mobile, connect DC power supply DTX-3.
- When landline phone rings, take hook off and make audio echo test when asked.
- Wait until testsequence is ready.
After successful RF final test disconnect TME-3 from DTX-3 and RF Tester
NOTE: Audio lines pin 23+25 (MIC+/-) and 26+28 (Ear+/-) from M2M connector are already tested
by audio echo test.