User Guide

After Sales
Technical Documentation
TESLA Service Software User Guide
THA–4S
Page 37
Original, 12/95
User Data Transfer
Selecting Dealer / User Data Transfer allows all the User data (excluding
the ESN) to be transferred from one phone and programmed into another
phone. Also in this dialogue box you are able to reset all the following
parameters to the factory default values:
 Subscriber (NAM) numbers
 Short Code Memory
 SID Screening Table
 User Menu Settings
An example of the user data transfer dialogue box is shown
below.
Select with check boxes which information you wish to transfer or reset to
factory values.
In the dialogue box the following buttons are available:
 File Load ( Alt + L ) – reads user data from a file. You can select a file
to be loaded from the File selection dialogue box. Only items that were
checked can be read back.
 File Save ( Alt + S ) – writes user data to a file. You can select the file
to write to from the File selection dialogue box. Only items that were
checked can be stored to the file.
 Read Phone ( Alt + R ) – reads user data items that are checked from
the phone.
 Write Phone ( Alt + W ) – writes user data to the phone. Before writing
the user is asked to confirm the writing.
 Reset ( Alt + T ) – Resets the checked items to the original factory
values.
 Esc–Close – closes the user transfer dialogue box. Click the button or
press the ESC key.