CCS Technical Documentation RH-42 Series Transceivers Assembly Issue 2 09/2003 Confidential Nokia Corporation
RH-42 Assembly Page 2 CCS Technical Documentation Nokia Corporation Confidential Issue 2 09/2003
RH-42 Assembly CCS Technical Documentation Assembling the RH-42 Basic Transceiver Assemble the D-cover assembly. 1. Step 1. Assemble the metal deck from the back cover side by pressing it with your fingers. All six tabs should snap into the slots in the D-cover. 2. Step 2. Place the IR window onto the D-cover before assembling the antenna. Step 4. Press the antenna into its place. Note: Make sure that the antenna springs do not get damaged or touched during assembly.
RH-42 Assembly CCS Technical Documentation Step 9. Place the vibra assembly into its slot. Use tweezers. The vibra is assembled into the D-cover with interference fixing. 6. Note: If the battery connector or the buzzer assembly is in place, make sure that the battery connector springs and the buzzer springs stay intact. The springs may be damaged, if touched. Step 10. Place the buzzer assembly into its place. Use tweezers. 7. The buzzer is assembled into the D-cover with interference fixing. 8.
RH-42 Assembly CCS Technical Documentation Note: The use of gloves is mandatory in order to prevent fingerprints from appearing on the engine layout. Use ionized air or a vacuum, before assembling the D-cover, to remove dust and other foreign particles from the PWB assy. 11. Place the engine module on top of the LCD module. Place the system connector on top of the engine module. 12.
RH-42 Assembly CCS Technical Documentation 17. Assemble the battery. Step 1. Push the battery connector interface. Step 2. Press the battery down so that the latch fits the battery in place. Assemble the back cover. Step 1. Place the back cover on the phone. 18. Step 2. Slide the cover so that the spring snaps the cover into place.
