User Guide

PAMS
Technical Documentation
NHB–3
Service Software Instructions
Original 26/97
Page 52
Appendix II
Starting options for service software
The program is started by entering the following command:
NHB2SERV [–serial port] [–video mode] [–text mode] [–file name]
where:
[–serial port] = the communication port used for M2BUS
(COM1 or COM2). –c1 or –c2
[–video mode] = video control method (BIOS video or HW
video). –vb or –vh (default) Note: If PCLocals
screen updating is slow, try change this option.
[–text mode] = screen text mode (CO80, MONO, BW80
or last mode). –tco80, –tmono, –tbw80 or –tlast
(default)
[–file name] = name of the configuration file. –ffilename
(default filename is –fNHE_4.CON)
Example 1; The program is to be used to test the NHB–2 phone.
NHB2SERV <Enter>
Example 2; The program is used to test the NHB–2 phone, using a PC with
black–and–white display. In addition, use of BIOS controls is desirable to avoid
compatibility problems.
NHB2SERV –TBW80 –VB <Enter>