User Guide

PAMS
Technical Documentation
NHB–3
Service Software Instructions
Original 26/97
Page 50
7 – Phone Mode
With this function you can change the phone state (PCS or local mode).
When PCS is selected the normal start up functions take place in the phone
and the phone is in normal operating mode.
When you are selecting the PCS mode, the phone tries to synchronize into the
base station and the waiting window appears into the screen. If the phone gets
the connection, the waiting window will be removed (you do not need press the
<Esc> key) and the AFC value witch used can be read from the phone. This
value is used when selecting local mode.
If the phone does not connect the base station, the middle value of the AFC is
used in the local mode.
When the local mode is selected the phone is deactivated to enable e.g. special
RF tuning, adjustment values are requested from the phone and used to control
hardware and the AFC value is stored in the AFC control register.
Q – Quit
With this selection you can terminate (quit) the program.