User Guide

PAMS
Technical Documentation
NHB–3
Service Software Instructions
Original 26/97
Page 47
4.8 – Set Factory Values
Factory values setting message is sent to MS with this function.The user is
asked to confirm the function with <Y> key.
When selection is accepted the waiting window is made. When factory set is
done (response message received) the waiting window is removed. The waiting
window tells the needed time. If the waiting window is removed with <Esc> key,
it has no effect to factory set command. <Esc> key only causes that it is impos-
sible to see when factory set is done.
After the factory values are set user should make all tunings of the phone.