User Guide

PAMS
Technical Documentation
NHB–3
Service Software Instructions
Original 26/97
Page 35
3.3.2 – Channel
This informs the normal operating RF channel number. Normal channel num-
bers can be selected. The same channel number is used both for transmission
and receiving. This updates same parameter as channel number in the RF con-
trols menu.
3.3.3 – 3.3.8 – Monitoring Channels
Channels for monitoring are specified with these six selections. All channel
numbers can be used. If more than one selection has the same number, the
monitoring channel list (neighbour list) will have less than 6 selected channels.
The minimum number of monitoring channels is one (all channels have same
value). The monitoring channel can also have same value as normal operating
channel. The first monitoring channel updates same parameter as monitoring
channel in the RF controls menu.
3.4 – Internal Audio Loop
Test interface input and output (internal/external) is possible to select. The third
selection connects and disconnects the test loop. The sent audio signal level
has constant value which depends on the selected interfaces.
When <Esc> key is used, the internal loop is automatically ended (loop=off).