User Guide

PAMS
Technical Documentation
NHB–3
Service Software Instructions
Original 26/97
Page 22
3.2 – Adjustments
If EEPROM fault is noticed when local mode was selected, it is not possible to
select adjustments menu.
All adjustments which have EEPROM saving selection have the next kind of be-
having with <F2> and <Esc> keys:
When adjustment function is activated and <F2> key is used the program will
ask are the values saved to the EEPROM or not. If <Y> key is used, adjustment
values are saved to the EEPROM. If <N> or <Esc> key is used the adjustment
can be continued. Nothing happends if any other key is used.
When <Esc> key is used during adjustment function, the program will ask are
the values saved to the EEPROM or not. If <Y> key is used, adjustment values
are saved to the EEPROM and exit from the function is performed. If <N> key is
pressed exit will be performed without saving the values to the EEPROM. If
<Esc> key is used the adjustment can be continued. Nothing happends if any
other key is used.
3.2.1 – Continuous Mode Channel
Continuous mode channel number can be selected from adjustments menu.
The real frequency (transmission or receiving frequency area) depends on the
active unit selection and the selected tuning function. Note that this is same
selection as in the RF controls menu.