User Guide

PAMS
Technical Documentation
NHB–3
Service Software Instructions
Original 26/97
Page 19
3.1 – RF Controls
RF Control Information Window
When RF controls menu is activated, the information window will be generated
and it is updated when information is changed. This window is removed when
exit is made from RF controls menu. The shown window type is used when
burst operation mode is selected.
The text in the window has same meaning as in the selection menus. TX Power
have value OFF or transmission power as PCS value. When the TX power is
tuned with test value (smallest value) the TX Power has value TEST.
AGC value is shown only when its value is controlled by PC. When Active Unit
has value RX and Operation Mode is continuous, AGC is controlled by PC ex-
cept when next adjustment functions are activated:
– RSSI calibration
– AFC diagram
AFC value is shown only when its value is controlled by PC. When Active Unit
has value RX and Operation Mode is continuous, AFC is controlled by PC.