User Guide

PAMS
Technical Documentation
NHB–3
Service Software Instructions
Original 26/97
Page 18
2 – Initialize Phone
With this function you can initialize the phone to accept M2BUS commands
from the PC. This function should be used right after the phone is connected to
PC and powered up.
The initialization function performs the following subfunctions:
– MBUS registration
– Test mode message sent to the phone
– Phone mode set to PCS
3 – Testing and Adjustments
When testing and adjustment menu is selected, the phone mode must be set to
the ”Local” value.
Caused by the test interface slowness when M2BUS is used there may be
some delay between the user interface updating and the register controls in the
hardware.