User Guide

PAMS
Technical Documentation
WinTesla User Guide
NHD–4
Page 79
Original 11/97
Error – System hangs or Locks up
Wintesla may hang or Lock up if it is being run on Windows 95 or NT.
Solution
Run the Wintesla application on Windows 3.1 or 3.11. The Wintesla
application is NOT designed to run under Windows 95 or NT. If you are
using Windows 3.1 or 3.11 and are still experiencing problems please call
your local Authorized Service & Support location.
Error – Reset FPS–3 box
This error only occurs when reflashing a phone with new software.
Solution
Remove power from the FPS–3C box for approximately 5 seconds. Then
reconnect power.
Error – Phone will not Tune properly
The phone can not be properly Tuned while connected to the FPS–3C
flash box. The voltage coming from the box will cause errors in the tuning
parameters.
Solution
Disconnect the FPS–3C box from the phone while Tuning. Only use one
of the set up configurations listed in the Dealer Setups section of the
NHD–4NX Service Manual.
Service and Support
Please contact your local Service location for more information and
support .
Or try our web site (http://www.Nokia.com)