User Guide

PAMS
Technical Documentation
WinTesla User Guide
NHD–4
Page 6
Original 11/97
Common User Interface
Due to the modular design of WinTesla, various generations of Nokia
products can be serviced, while sharing a similar user interface. The
common user interface is explained in the first part of this document and
is followed by the specific module information.
The software can be used to control the phone by entering commands via
the keyboard of a PC/AT – running MS Windows 3.1 or 3.11.
Note: Windows 95 and Windows NT are not supported.
This document refers to WinTesla Version 4.60 or greater.
Equipment Required
Computer : IBM 486 PC/AT or compatible with at least
one, unused serial port, COM1 or COM2 one parallel port
(LPT1), 5 Meg. hard disk space required, 16 Meg of RAM
 : Any supported by MS Windows version 3.1 or 3.11
Operating System : DOS 5.0 or later running MS Windows
3.1 or 3.11
WinTesla Application Software (product code 0774046)
Software Protection Key PKD–1 (product code – 0750018)
Mechanical Connections
The software controls the phone via a separate adapter (DAU–2)
connected to the serial port of the PC and to the phone’s bottom
connector using the Nokia proprietary communication method called
M2BUS.
Attach the protection key PKD–1 to parallel port one (25–pin female
D–connector) of the PC. When connecting the PKD–1 to the parallel port
be sure that you insert the PC end of the PKD–1 to the PC (male side).
Figure 1.Dongle Insertion