User Guide

PAMS
Technical Documentation
WinTesla User Guide
NHD–4
Page 58
Original 11/97
CDMA Testing
This screen is used when testing and troubleshooting the phone in CDMA
mode. Below is an example screen.
Keys:
PDM Ctrl – Opens the PDM Control Screen.
ADC Reading – Opens the ADC reading screen.
Quick RX Test – Opens the Quick Receiver test screen.
Mbus Test – Tests the communication between the phone and the
computer.
Close – Exits the current screen.
RHO on:
RHO on – turns the CDMA transmitter on/off.
LNA on:
LNA on – turns the CDMA receiver’s Low Noise Amplifier on/off.
Troubleshooting mode on:
Troubleshooting Mode on – will set the phone into CDMA mode for
technical troubleshooting. This mode is the Local mode for CDMA.
CDMA TX Bias Tuing Functionality Test
Manual Test
To verify this functionality manually, complete the CDMA TX Bias tuning in
the Service Software, or perform the following steps:
1. Initiate the CDMA TX Manual Gain controls from the CDMA Test menu
located in the Service Software.
2. Set the CDMA TX Gain to minimum. There should be less than –30
dBm of CDMA output band power.