User Guide

PAMS
Technical Documentation
WinTesla User Guide
NHD–4
Page 52
Original 11/97
AMPS / BaseBand Test Screen
This screen is used when testing and troubleshooting the phone in AMPS
mode. Below is an example screen.
Keys:
High – Sets the AMPS channel to the Highest Frequency according to the
Frequency planning set in the “configure” menu.
Mid – Sets the AMPS channel to the Middle Frequency according to the
Frequency planning set in the “configure” menu.
Low – Sets the AMPS channel to the Lowest Frequency according to the
Frequency planning set in the “configure” menu.
Up – Increments the channel selection by one.
Dn – Decrements the channel selection by one.
PDM Ctrl – Opens the PDM Control Screen.
ADC Reading – Opens the ADC reading screen.
Quick RX Test – Opens the Quick Receiver test screen.
Mbus Test – Tests the communication between the phone and the
computer.
Close – Exits the current screen.