User Guide

PAMS
Technical Documentation
WinTesla User Guide
NHD–4
Page 23
Original 11/97
Equipment Setup
Caution: Make sure that you have switched off the PC and the printer
before making connections !
Caution: Do not connect the PKD–1 key to the serial port. You may
damage your PKD–1 !
Attach the protection key PKD–1 to parallel port one (25–pin female
D–connector) of the PC. When connecting the PKD–1 to the parallel port
be sure that you insert the PC end of the PKD–1 to the PC (male side). If
you use a printer on parallel port one, place the PKD–1 between the PC
and your printer cable.
Next connect the M2BUS adapter to the serial port (RS–232) of the
computer. In case you are using a 9–pin serial port (normal with an AT
set) use the mating adapter supplied with the M2BUS adapter.
Attach one end of the XCM–1 modular cable to the DAU–2 PC/M2BUS
adapter and the other end to the JBS–7 service box. Use suitable adapter,
SCS–1 service cable when the covers of the phone are in place, JBS–8
test frame with the phone covers off, and attach it to the phone. Then
connect it to the service box.