User Guide

PAMS
Technical Documentation
WinTesla User Guide
NHD–4
Page 22
Original 11/97
HD881 Module
Information in this section is specific to the HD881 module and assumes
that the setup procedures in the common interface section have been
carried out.
Installing the HD881 Service Module
The HD881 Service module software is delivered on a 3.5” diskette and
must be run under the Wintesla core software package.
To install the HD881 Service Module software, proceed as follows:
Insert the HD881 Service Module diskette into drive A: of your PC.
From Windows File Manager select the file a:\install.exe and
press OK.
Follow the on screen instructions and select the
new install option when
prompted to do so.
Caution: The service module requires the Wintesla core software
application to be installed first for this module to function.
Note: Be sure to install the Service Module in the same directory as the Wintesla
core software application.
Required Servicing Equipment
The following is a list of equipment that is needed in order to service the
HD881 family of products along with their respective product codes.
 HD881 Software Service Module (0774062)
 Dongle ‘blackbox’ adapter DBA–1 (0630044)
 M2BUS adapter DAU–2 (0750006)
 RS–232 adapter, 9–to–25 pins (4626170)
 RS–232 cable (0730090)
 Centronics cable (0730029)
 Service cable SCS –1 (0770010)
 Service cable SCS–10 (0775059)
 Audio cable ADS–1 (0730011)
 Modular cable XCM–1 (4626131)
 Flash Programmer Set FPS–3C (0271330)
 Power connector PCS–1 (0730012)
 Modular T Connector cable (4626134)
 Dummy Battery BTS–4 (0770009)
 Covers off Jig JBS–8 (0770014)
 Service box JBS–7 (0770015)