User Guide

PAMAS
Technical Documentation
NHD–4
CAR Installation Guide
Page 8
Original 11/97
Power Cable (PCN–5, CARK–16 only)
The power cable connects to the compact HF holder via the 5.5 mm d.c.
plug. The red (+12V) and black (GND) wires connect to the battery via the
supplied fused connectors. Supply voltage may vary between 10.8 and
15.6 volts.
CAUTION !
Maximum supply voltage is 15.6 volts, minus (–) in the chassis of the
vehicle !
Overvoltage or wrong polarity may cause serious
damage to the car kit !
Handsfree Microphone (HFM–4)
The handsfree microphone can usually be installed on the drivers sunvisor
or A–pillar. The main idea is to get the microphone as close to the driver’s
mouth as possible, and to attach the microphone to a surface that is
mechanically quiet. The microphone connects to the corresponding 2.5
mm jack in the PHF–1.
Mobile Holder (MBH–6)
The holder unit MBH–6 offers firm attachment. It is usually attached to
Compact HF Holder PHF–1 with the Cradle Adapter Kit (MKE–4N), which
includes the cradle adapter, 4 screws and 4 nuts.To attach the MBH–6 to
the PHF–1 first you have to remove the lower cover of PHF–1 by
detaching the four crossheaded screws visible underneath the PHF–1
(Figures 1, 2). Insert the four provided nuts into the corresponding slots in
the cradle adapter MKE–4N, and slide the cradle adapter into its place
underneath the MBH–6 (Figure 3). Do not use mounting plate MKE–1 in
place of cradle adapter MKE–4N. Mount MBH–6 to its slot in the front part
of PHF–1, and finally attach it by using the provided screws (Figures 4, 5).
It is also possible to use the MBH–6 as a separate mobile holder, it is then
attached to the vehicle with MKE–1 or HHS–1.