User Guide

INSTALLATION

INSTRUCTIONS

9617ARo

4–2

NHC–4

Technical Documentation

Installation Instructions

This manual aims to give the required information for installing the handheld

telephone into a vehicle. Read this instructions carefully in order to minimize

the problems and malfunctions.

The suggested installation concepts give only general ideas about positioning

of the units. The installer should rely on his or her own skills and common

sense when choosing the locations.

The end user should never attempt to install the telephone without professional

assistance as the install requires special tools and knowledge. The terms of

warranty demands that the telephone is installed by an experienced installation

facility.

Note: Refer to the warnings below before commencing the installation

procedure.

WARNINGS!

–

ENSURE THE VEHICLE BATTERY IS DISCONNECTED BEFORE COMMENCEMENT

OF THE INSTALLATION PROCEDURE, AND THAT IT REMAINS DISCONNECTED

DURING THE PROCEDURE.

– DO NOT SMOKE OR USE NAKED FLAMES WHEN WORKING NEAR THE VEHICLE

FUEL SYSTEM.

– ENSURE THAT ELECTRICAL CABLES, HYDRAULIC LINES AND FUEL LINES ARE

NOT DAMAGED DURING INSTALLATION.

– CHECK THAT NORMAL CONTROL AND OPERATION OF THE VEHICLE IS NOT IM-

PAIRED BY THE INSTALLATION; IN PARTICULAR CHECK THE BRAKES AND STEER-

ING THOROUGHLY.

– ALTHOUGH ELECTRONIC SPEED CONTROL, ABS ANTI–LOCK BRAKE AND FUEL

INJECTION SYSTEMS ARE RELATIVELY IMMUNE TO MALFUNCTION CAUSED BY

NEARBY RADIO TRANSMISSIONS, SHOULD YOU EXPERIENCE FALSE OPERATION

OF THESE SYSTEMS OR ARE IN ANY DOUBT WHATSOEVER AS TO THEIR FUNC-

TIONALITY, PLEASE CONSULT THE VEHICLE DEALER.

– THE CAR KIT IS SUITABLE FOR USE ONLY IN VEHICLES WITH A 12 V NEGATIVE

EARTH SUPPLY. USE ON OTHER SUPPLY VOLTAGES OR ALTERNATIVE POLARITY

WILL DAMAGE THE EQUIPMENT.