User Guide

PAMS
Technical Documentation
NHC–4
NAM Programming Instructions
Original 09/97
Page 3
Keypad NAM Programming Mode
The NHC–4 phones CMT uses an EEPROM NAM that can be programmed di-
rectly from the standard user keypad. In order to access the NAM, you must
enter the special access code currently programmed to the phone. Once the
programming mode is accessed, NAM parameters are loaded by entering them
through the keypad and ”storing” them to selected memory locations. Be sure
to obtain all parameters before proceeding.
FOR AUTHORIZED DEALER USE ONLY
EASY NAM PROGRAMMING
1 Turn the phone on.
2 Enter the Easy NAM code. Access code is: #639#
3 Verify the display now reads ”Cellular number” and enter the 10 digit MIN for
the phone.
4 Press softkey under the word ”OK” in the display. If less than 10 digits are en-
tered an error message will prompt for you to re–enter the number.
5 Verify the display reads ”Enter code” and enter the five digit SID followed by
four zeros (example: 001750000 is a SID of 175 followed by four zeros). An er-
ror message will display if an incorrect entry is made. Do not add more than
four zeros to the code.
NOTE: Change the Lock code by adding a pound sign and new lock code after
the code (example: 001750000#7788 Lock code=7788).
Change the language code by adding a pound sign and new language code
after the code (example: 001750000#2 Language = 2).
Language Code: 0 (default)=English, 1=French, 2=Spanish, 3=Portuguese
Change the Lock code and Language code by separating each set of numbers
by a pound sign (example: 001750000#7788#2). The SID=00175, Lock
Code=7788, Language=2 (Spanish)
6 Press softkey under the word ”OK” in the display.
7 The display will tell you that the activation was OK and instruct you to power the
phone off, and then on again. When the phone powers back up, it will automati-
cally select the correct system (A or B).