User Guide

Nokia Customer Care Service Tools

2115i/2116/2116i (RH-66)

PKD-1 Software Security Dongle

The PKD-1 is a hardware dongle that, when connected to the parallel (LPT) port of the

PC, enables the use of the service software. It is not possible to use the service software

without the dongle. Printers or other peripheral devices can be connected to the PC

through the dongle, if needed.

Caution: Make sure that you have switched off the PC and the printer before making

connections.

Caution: Do not connect the PKD-1 to the serial port. You may damage your PKD-1

and/or your PC.

RJ-18 Power Amp LGA Rework Jig and ST-16 PA Stencil

The ST-16 stencil allows rework on LGA-type components that do not have pre-tinned

pads. Both power amps require the use of this stencil. The stencil is designed to

specifically fit the PA pad configuration and dimensions. The RJ-18 fits the physical

dimension of the PAs.

Note: Used in conjunction with the SPS-1 Paste Spreader.

Note: The RJ-13 is not intended to serve as a test jig.