User Guide

Introduction
Read this first
The Phoenix software is used to a number of different phones containing different versions of baseband
generations.
These instructions are intended as a general guide and are not product specific, where a Phoenix SW version
is shown you should use the relevant version for your product and in the screen shots where a type designator
is shown you should read the type designator for your product.
Service software installation
Phoenix installation steps in brief
Phoenix is the DCT-4 generation service software for reprogramming, testing and tuning the phone.
To install Phoenix, you need to:
Connect a DK2 Dongle or FLS-4S POS Flash Device
Install the Phoenix Service SW
Install the Data Package for Phoenix
Configure users
Manage connection settings (depends on the tools you are using)
Phoenix is now ready for FLS-4S Point Of Sales Flash Device use.
If you use FPS-8:
Update FPS-8 SW
Activate FPS-8
Update JBV-1 Docking Station SW (only when needed)
Phoenix is now ready to be used with FPS-8 flash prommer and other tools as well.
The Phoenix Service Software installation contains:
Service software support for all phone models included in the package
Flash update package files for FPS-8* and FLS-4S programming devices
All needed drivers for:
DK2 dongle
FLS-4S point of sales flash device
USB devices
Note: Separate installation packages for flash update files and drivers are also available, but it is not
necessary to use them unless updates appear between Phoenix Service SW releases. If separate update
packages are used, they should be used after Phoenix and data packages have been installed.
Supported operating systems
Windows 2000 and XP.
Hardware requirements for using Phoenix
Minimum: Processor 300 MHz, RAM memory 64 MB, disk space 100 MB.
Recommended for Windows 2000: Processor 700 MHz, RAM memory 256 MB, disk space 150 MB.
RH-70
Phoenix service software Nokia Customer Care
9243364 (Issue 1, Part 1) Company Confidential Page 3–5
Copyright ©2005 Nokia. All Rights Reserved.