User Guide

RH-18/38 Company confidential
CCS Technical Documentation
Page 80 Nokia Corporation. Issue 1 10/03
3 Select the modulation 1, 0 or random in Tx Data Type. Select random if a GSM
tester is used. Then it can synchronise to the burst.
4 Select Tx PA Mode High
5 Tune the highlighted values to the wanted power (Use average burst power)
6 Tune base level to –28dBm (Close to lowest level CMD55 can keep synchronisa-
tion)
7 Calculate coefficients
8 Select Tx PA Mode low and tune the high lighted values.
9 The base level coefficient is taken from the high mode. Do not change it.