Installation Instructions
Table Of Contents
- Requirements for Installation and Operation
- 1 About this document
- 2 Environment
- 3 Installation requirements
- 4 Cabinet interfaces and cables
- 5 Installation equipment
Requirements for Installation and Operation
42 (44) © Nokia Corporation Draft DN9913471
Nokia Proprietary and Confidential Issue 3-0 en
Note
Additional equipment includes:
• LMP cable for connecting the manager PC to the BTS
• antistatic wrist strap
• spirit level for checking the horizontal level of the BTS
• tape measure
• cable ties for securing the cable routing out of the BTS
• crimping tool for fitting a crimp terminal to the grounding cable
A set of tools needed for assembling the cable connectors is available from Nokia.
• cable stripper for preparing the grounding cable
• ladder (depending on the installation height from the ground)
• 10 mm spanner for removing the grounding bridge on the transmission unit
(optional)
• T20 Torx torque driver for removing and tightening the BTS cover top
retaining screws (optional)
• centre punch for marking drill hole locations when mounting the BTS on a
wall (optional)