Product Info
Table Of Contents
- Commissioning
- 1 About this document
- 2 Commissioning software overview
- 3 Preparing for commissioning
- 4 Getting started with BTS Manager
- 5 Commissioning Wizard process
- 6 Traffic Manager
- 7 Line interface and synchronization settings
- 8 Radio Wizard
- 9 Cross-connections
- 10 Commissioning Report
- 11 Troubleshooting and fault reporting
- Appendix A. LMP connector description
Commissioning
62 (78) © Nokia Corporation Draft DN999099
Nokia Proprietary and Confidential Issue 4-0 en
Note
Note
Figure 29. Flexbus 2 settings for the MetroHopper outdoor unit
The Temporary Hop ID on the MetroHopper General Settings page must be the
same for both the master and slave terminal.
Select ‘Manual’ under ‘Channel Selection’ on the Flexbus 2 -
MetroHopper General Settings page. When you click NEXT, the Flexbus
2 - MetroHopper Manual Channel Selection page appears (see Figure 30).
Select one channel to be used. You can also click MEASURE to measure
the signal strength of the selected channels and then select the best channel.
At least one channel must be selected, before you can continue to the next page.