Product Info
Table Of Contents
- Commissioning
- 1 About this document
- 2 Commissioning software overview
- 3 Preparing for commissioning
- 4 Getting started with BTS Manager
- 5 Commissioning Wizard process
- 6 Traffic Manager
- 7 Line interface and synchronization settings
- 8 Radio Wizard
- 9 Cross-connections
- 10 Commissioning Report
- 11 Troubleshooting and fault reporting
- Appendix A. LMP connector description
Line interface and synchronization settings
DN999099 © Nokia Corporation Draft 55 (78)
Issue 4-0 en Nokia Proprietary and Confidential
4. Select the ‘Power’ option as ‘On’.
5. If the transmission unit type is FXC RRI, check or modify the settings for
the other line interfaces, as described in steps 1 - 4.
6. Click OK to accept the changes.
Figure 24. LIF settings with the FXC RRI unit
7.2 Synchronization settings
The contents of the Synchronization dialogue box depends on the type of
transmission unit, F(X)C E1/T1 or RRI. There is no Synchronization dialogue
box for the FC RRI unit.
7.2.1 Synchronization settings for F(X)C E1/T1 transmission units
Define the E1/T1 synchronization settings as follows:
1. Select the ‘Timing’ option for priority 1 as ‘Rx Clock’ and select the
interface that is used for synchronization (uplink direction).
If the transmission unit in the BTS configuration is F(X)C E1/T1, you can
define settings for other priorities.