Product Info
Table Of Contents
- Commissioning
- 1 About this document
- 2 Commissioning software overview
- 3 Preparing for commissioning
- 4 Getting started with BTS Manager
- 5 Commissioning Wizard process
- 6 Traffic Manager
- 7 Line interface and synchronization settings
- 8 Radio Wizard
- 9 Cross-connections
- 10 Commissioning Report
- 11 Troubleshooting and fault reporting
- Appendix A. LMP connector description
Commissioning
48 (78) © Nokia Corporation Draft DN999099
Nokia Proprietary and Confidential Issue 4-0 en
Note
6.1.3 Allocating for EDGE dynamic Abis transmission
Dynamic Abis uses the EGPRS dynamic Abis pool (EDAP) to efficiently allocate
transmission resources for the higher EDGE data rates.
EDAP resources are shared between EDGE TRXs in a single BTS, chained BTSs,
or cross-connected BTSs. The available TRXs are allocated in Traffic Manager
from the EDAP command.
Allocate TRXs to the EDAP as follows:
1. Select the incoming line interface port according to the transmission unit
used and then click the EDAP button.
2. Select the start time-slot by clicking with the mouse. Drag the mouse to the
end time-slot and release. The EDAP Properties dialogue box is opened
(see Figure 19).
The EDAP Properties dialogue box appears automatically when you have
selected more than 11 available timeslots.
Figure 19. Starting EDAP time-slot selection