Product Info
Table Of Contents
- Commissioning
- 1 About this document
- 2 Commissioning software overview
- 3 Preparing for commissioning
- 4 Getting started with BTS Manager
- 5 Commissioning Wizard process
- 6 Traffic Manager
- 7 Line interface and synchronization settings
- 8 Radio Wizard
- 9 Cross-connections
- 10 Commissioning Report
- 11 Troubleshooting and fault reporting
- Appendix A. LMP connector description
Traffic Manager
DN999099 © Nokia Corporation Draft 47 (78)
Issue 4-0 en Nokia Proprietary and Confidential
Figure 18. Example of traffic allocation for five TRXs in a two BTS chain
Alternative 2.
Click the TRXSIG on TCHs button and then click the first bit in a time-slot
you reserved for TCHs in Step 2. Select the link speed from the pop-up
menu. Repeat for all TRXs in the BTS configuration. Click the OMUSIG
button and then click a cell in the Abis allocation table. Select the link
speed from the pop-up menu.
Alternative 3.
Click the OMUSIG/TRXSIG1 button and then click the first bit in the
TCHs allocation for TRX 1. Select the link speed from the pop-up menu.
Click the TRXSIG or TRXSIG on TCHs button and allocate TRXSIG
capacity for the other TRXs in the BTS configuration.
3. If EDGE transmission is not required, proceed directly to Section 6.1.4 to
complete the Abis transmission allocation. For EDGE transmission,
proceed to Section 6.1.3to allocate EDGE TRXs to the dynamic Abis pool
(EDAP).