Product Info
Table Of Contents
- Commissioning
- 1 About this document
- 2 Commissioning software overview
- 3 Preparing for commissioning
- 4 Getting started with BTS Manager
- 5 Commissioning Wizard process
- 6 Traffic Manager
- 7 Line interface and synchronization settings
- 8 Radio Wizard
- 9 Cross-connections
- 10 Commissioning Report
- 11 Troubleshooting and fault reporting
- Appendix A. LMP connector description
Commissioning
36 (78) © Nokia Corporation Draft DN999099
Nokia Proprietary and Confidential Issue 4-0 en
Note
Note
10. On the EAC Output Settings wizard page (Figure 11), test the required EAC
outputs by ticking the ‘In use’ check box and testing the functionality of the
outputs in real time. Mark tested outputs as ‘Checked’.
When you have finished the EAC output settings, click the SET OUTPUTS
button to send the information to the BTS.
After you have completed the required EAC output settings, click NEXT.
The NEXT button remains disabled until you click a check mark in the ‘Checked’
check box for all outputs that are ‘In Use’.
The EAC names and polarities are defined at the BSC.
Figure 11. Setting and testing EAC outputs in real time