Product Info
Table Of Contents
- Commissioning
- 1 About this document
- 2 Commissioning software overview
- 3 Preparing for commissioning
- 4 Getting started with BTS Manager
- 5 Commissioning Wizard process
- 6 Traffic Manager
- 7 Line interface and synchronization settings
- 8 Radio Wizard
- 9 Cross-connections
- 10 Commissioning Report
- 11 Troubleshooting and fault reporting
- Appendix A. LMP connector description
Commissioning Wizard process
DN999099 © Nokia Corporation Draft 35 (78)
Issue 4-0 en Nokia Proprietary and Confidential
Note
Note
The state of each EAC will change in real time as you test it the alarm.
Then, the appropriate state changes from ‘Open’ to ‘Closed’, or vice versa.
After testing the EACs, mark them as ‘Checked’. When you have
completed the testing, click NEXT.
If the EAC inputs will not be used, just click NEXT without marking any
checkboxes.
The NEXT button remains disabled until you click a check mark in the ‘Checked’
check box for all inputs that are ‘In Use’.
Figure 10. Setting and testing EAC inputs in real time