Product Info
Table Of Contents
- Commissioning
- 1 About this document
- 2 Commissioning software overview
- 3 Preparing for commissioning
- 4 Getting started with BTS Manager
- 5 Commissioning Wizard process
- 6 Traffic Manager
- 7 Line interface and synchronization settings
- 8 Radio Wizard
- 9 Cross-connections
- 10 Commissioning Report
- 11 Troubleshooting and fault reporting
- Appendix A. LMP connector description
Commissioning
32 (78) © Nokia Corporation Draft DN999099
Nokia Proprietary and Confidential Issue 4-0 en
Note
Figure 7. Opening Traffic Manager from Commissioning Wizard
When you have completed the allocation in Traffic Manager and you return
to this wizard page, the BACK button is disabled because the transmission
configuration has been loaded to the BTS and the transmission connection
is established between the BTS and the BSC. If the connection fails, see
Chapter 11 of this document, ‘Troubleshooting and fault reporting’.
If you need to change any of the parameters you have specified prior to this
point, click CANCEL, run the ‘Undo Commissioning’ procedure and then
re-commission the BTS with the correct parameters.
Commissioning Wizard will automatically proceed to the next wizard page after
you have allocated the incoming Abis capacity and the BTS is ready for testing.
7. Depending on the status of the Abis connection, proceed either from Abis
connected or Abis not connected.
1. Abis connected: